This is a white 3D printed camera mount for a Blink 4 Camera. It has four holes for screwing or bolting onto a wall or flat surface such as inside a bird house or a gourd lid and keeping it as flush to the mounting surface as possible to reduce the space it takes up.
The mount is 3" from side to side, and 3.8" approximately from corner to corner.
The camera snaps into place and is held securely even if upside down.
To remove the camera DO NOT flex the retaining tabs out by hand, simply pull on the corners off the camera and it will push the tabs out of place and be released. Flexing the tabs out by hand may put too much force on them and cause them to break. Pulling the camera out itself will not.
It is not compatible with the extended battery. If you want a camera mount that is compatible with an external solar panel and wire to charge it please let us know in the order comments.
