This is a set of two 3D printed camera mounting components for a Blink 4 Camera. It is designed to mount the camera to a 1/2 Schedule 40 PVC pipe (not included) to allow the camera to stand off any required distance.
The mount is 3" from side to side, and 4.5" approximately from top to bottom
The camera snaps into place and is held securely even if upside down.
Both components have 4 mounting screw locations for mounting to flat surfaces (if preferred for the camera mount) and two screw locations for locking onto the PVC pipe in whatever orientation is required.
To remove the camera DO NOT flex the retaining tabs out by hand, simply pull on the corners off the camera and it will push the tabs out of place and be released. Flexing the tabs out by hand may put too much force on them and cause them to break. Pulling the camera out itself will not.
It is not compatible with the extended battery. If you want a camera mount that is compatible with an external solar panel and wire to charge it please let us know in the order comments.
