Flatline 2011 Thumb rest

*Patent Pending*

After years of testing we are releasing the new and innovative Flatline Thumb Rest!

Super easy to install with no fitting needed*. It locates in the front frame screw, under the frame and into the front rail on many 1911 double stacks or 2011's.

Simply replace the left side screw with the longer torx screw included to hold it in place. We recommend the use of red threadlocker to keep everything tight (Don't forget to heat the screw if ever you want to remove it!).

This low profile rest gives more than enough support for a consistent thumb placement while fitting in many holsters without needing modification! With others just a small area can be heated to allow the kydex to re-shape as you push the gun into the holster to the required position*.

* Because it is low profile it works with many holsters already or just needs a slight adjustment with a heat gun, however it will not work with Race holsters because of how it is mounted to the grip frame screw.

The Flatline thumb rest still allows the use of "most" weapon mounted lights and fits into the IDPA box to keep you legal in your IDPA competitions.

Screws included. Be sure to use the right one for your gun. You want the longest one possible that holds the Flatline tight against the frame and grip. If you are installing on a Bul gun we have metric screws available here  Or request we swap them over to metric in your order comments.

We have Torx bits for install available here.

We are working to check fit on as many guns as possible. If you don't see yours above or listed below we are working on it. We don't have access to all the guns and all the grips available so can't guarantee fit if you have a gun or combination that we haven't seen in person. We will have a blog post going through the most important items to measure check asap. If you have used the thumbrest and it fits a gun we haven't mentioned please email us and let us know so we can tell everyone else!

Compatibility list.

MPA guns. The gun must have a picatinney rail. If yours does not then it will not fit. 

Any Staccato copy will use the Staccato #1 (this includes earlier STI guns)

#1, #4, #5 & #8 are the most generic options. #2, #3 &#7 are specialized for the guns mentioned.

*On most guns no fitting is needed but we all know there are a gazillion versions of the 1911 Doublestack guns so we can't guarantee it for every one and every model.